Follow

Setting Up Your Lavatube BC TubeTank.

Lavatube BC TubeTank Anatomy:

A: Base- The base contains the heating coil and is where the Lavatube BC TubeTank connects to the Lavatube.
B: Ultra-Port™ Heating Coil- This is a self contained replaceable heating coil. 
C: Air Shaft- This air shaft connects into the heating coil when assembled and delivers vapor to the Drip Tip.  
D: 4.5ml Tank- This is where the eLiquid is filled into the Lavatube BC TubeTank.
E: Drip Tip Connection- This is the connection point for your drip tip


Filling your Lavatube BC TubeTank- Step 1:

A: Unscrew

Remove the Lavatube BC TubeTank from the Lavatube. Turn the Lavatube BC TubeTank upside-down so the Drip Tip(E) is pointing down.

Remove the Base (A) of the Lavatube BC TubeTank by unscrewing it from the Tank (C) to expose the inner tank well.


Step 2:


B: Fill

Fill the Lavatube BC TubeTank by dripping eliquid into the Tank (D). Make sure you do not drip any eliquid into the center air shaft.

C: Fill Limit
Make sure you do not fill the eliquid past the end of the air shaft. If you do this, the air shaft will flood with eliquid and the eliquid will leak out the bottom of the Lavatube BC TubeTank when you reassemble it. It is best to stop filling when the eliquid level reaches the thicker part of the Tank window. See (F) in image below. 



Step 3:
D: Reassemble 
Replace the base of the Lavatube BC TubeTank by screwing it back together with the tank well. Make sure to screw it together firmly without misthreading the screw points.

E: Clean-up

After filling, wipe away any liquid on BC TubeTank connection
threads for best care and performance.

*Primer Puffs
To prime your heating coil before use, take a few primer puffs to pull liquid into the chamber. Do his without pressing the activation button to ensure the heating coil gets fully saturated with eliquid.


Replacing The Lavatube BC TubeTank Heating Coil:

The life expectancy of the heating coil will vary depending on frequency of use. Follow these easy steps to replace your heating coil with a new one. 


A: Remove 

Remove your Lavatube BC TubeTank from your Lavatube and disasemmble it as if you were going to refill it. 

After you've disassembled your Lavatube BC TubeTank, remove the old heating coil from the base, by unscrewing it.


B: Replace
Using a replacement Ultra-Port™ BC Tube Tank Heating Coil, screw it into the base. Refill and reassemble the Lavatube BC TubeTank to use. 


Primer Puffs
To prime your heating coil before use, take a few primer puffs to pull liquid into the chamber. Do his without pressing the activation button to ensure the heating coil gets fully saturated with eliquid.

Was this article helpful?
2 out of 2 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk