Follow

Replacing the Coil in the Kanger Subtank Nano.

Replacing The Kanger Subtank Nano Heating Coil:

The life expectancy of the heating coil will vary depending on frequency of use. Follow these easy steps to replace your heating coil with a new one. Replacement of the heating coil should be done after the vapor production decreases, or a noticeable flavor change.


  1. Unscrew your Kanger Subtank Nano form your mod. 
  2. Point the Drip Tip of the Kanger Subtank Nano downward and unscrew the base plate from the Tank Housing. Set the Tank Housing to the side in a safe place where it will not spill any of your e-liquid that is left in the tank. 
  3. After you've disassembled your Kanger Subtank Nano. Remove the old Kanger Subtank Nano coil from the base, by unscrewing it.
  4. Using one of the replacement Kanger Subtank Nano coils, screw in a new one into the base.
  5. Prime the coil and refill the tank following these instructions
  6. Reassemble the Kanger Subtank Nano. 

Clean-up

After filling, wipe any liquid off the Kanger Subtank Nano and the 510 threaded connection for best care and performance.

 

***Replacement coils for the Kanger Subtank Nano come in a choice of Ω ratings: 0.5 OHM KANTHAL or 0.15 OHM NICKEL Ni200. ***

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk